Lenze 8400 TopLine - Manual (Page 913)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
913
17 Parameter reference
17.2 Parameter list | C00121
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00121
C00122
C00123
C00129
Parameter | Name:
C00121 | Warning threshold motor temperature
Data type: UNSIGNED_16
Index: 24454
d
= 5F86
h
Operating threshold for error message "Motor: Temperature at Res./Enc. > C121"
• The response for reaching the threshold can be selected in C00583 .
• The current motor temperature is displayed in C00063 .
 Encoder/feedback system: Motor temperature monitoring (KTY)
Setting range (min. value | unit | max. value)
0 °C 250
Subcodes Lenze setting Info
C00121/1 120 °C Warning threshold motor temperature resolver
C00121/2 120 °C Warning threshold motor temperature MultiEncoder
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00122 | Initial value motor overload (I²xt)
Data type: UNSIGNED_16
Index: 24453
d
= 5F85
h
From version 12.00.00
The thermal motor load displayed in C00066 is pre-initialised with the value set here when the device is connected
to the mains.
• If "100.00 %" is set, the last value at switching off the device is used for the initialisation.
• Recommended setting for operation according to UL: 50.00 %
 Motor overload monitoring (I2xt)
Setting range (min. value | unit | max. value)
0.00 % 100.00
Subcodes Lenze setting Info
C00122/1 0.00 % Initial value motor overload (I²xt)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00123 | Device utilisation threshold (Ixt)
Data type: INTEGER_16
Index: 24452
d
= 5F84
h
Operating threshold for the "OC5: Device overload (Ixt)" error message
• The response for reaching the threshold can be selected in C00604 .
• The current device utilisation is displayed in C00064 .
Setting range (min. value | unit | max. value) Lenze setting
0.00 % 200.00 100.00 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00129 | Brake resistance value
Data type: UNSIGNED_16
Index: 24446
d
= 5F7E
h
Resistance value of the connected brake resistor
• The value to be entered can be obtained from the nameplate of the brake resistor.
Setting range (min. value | unit | max. value) Lenze setting
0.0 Ohm 500.0 39.0 Ohm
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10