Lenze 8400 TopLine - Manual (Page 935)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
935
17 Parameter reference
17.2 Parameter list | C00190
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00190
C00191
C00192
Parameter | Name:
C00190 | L_NSet_1: Setpoint arithmetic
Data type: UNSIGNED_8
Index: 24385
d
= 5F41
h
The L_NSet_1 FB: Selection of arithmetics
• To be able to influence the main setpoint (NSet) by an additional setpoint (NAdd).
Selection list (Lenze setting printed in bold)
0 Out = Set
1 Out = Set + Add
2 NOut = NSet - NAdd
3 NOut = (NSet * NAdd) / 100%
4 NOut = (NSet * 1%) / |NAdd|
5 Out = (Set*100%)/(100%-Add)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00191 | Logbook access index User
Data type: UNSIGNED_8
Index: 24384
d
= 5F40
h
From version 12.00.00
 Logbook read interface
Setting range (min. value | unit | max. value)
0 255
Subcodes Lenze setting Info
C00191/1 255 Logbook access index User
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00192 | Logbook data User
Data type: OCTET_STRING
Index: 24383
d
= 5F3F
h
From version 12.00.00
 Logbook read interface
Display range (min. value | unit | max. value)
Subcodes Info
C00192/1
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT