Lenze 8400 TopLine - Manual (Page 1123)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
1123
17 Parameter reference
17.2 Parameter list | C00915
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00915
C00916
C00917
C00918
Parameter | Name:
C00915 | Motor cable length
Data type: UNSIGNED_16
Index: 23660
d
= 5C6C
h
Single motor cable length for calculating the motor cable resistance
• The calculated motor cable resistance is displayed in C00917 .
Setting range (min. value | unit | max. value) Lenze setting
0.0 m 1000.0 5.0 m
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00916 | Motor cable cross-section
Data type: UNSIGNED_16
Index: 23659
d
= 5C6B
h
Motor cable cross-section of a phase/cable for calculating the motor cable resistance
• The calculated motor cable resistance is displayed in C00917 .
Setting range (min. value | unit | max. value) Lenze setting
0.50 mm^2 100.00 6.00 mm^2
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00917 | Motor cable resistance
Data type: UNSIGNED_16
Index: 23658
d
= 5C6A
h
Display of the motor cable resistance of a motor cable phase
• The motor cable resistance is calculated from the motor cable length set in C00915 and the motor cable cross-
section set in C00916 .
Display range (min. value | unit | max. value)
0 mOhm 64000
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00918 | SC: Start motor magnetising current
Data type: UNSIGNED_8
Index: 23657
d
= 5C69
h
If the servo control ( SC ) mode is selected and the controller is enabled, the speed setpoint for motor control will only
be enabled when the motor magnetising current has reached the threshold value set here.
• The adjustable percentage threshold value refers to the rated magnetising current ( C00095 ).
Setting range (min. value | unit | max. value) Lenze setting
0 % 90 87 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1