Lenze 8400 TopLine - Manual (Page 1199)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
1199
17 Parameter reference
17.2 Parameter list | C01300
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01300
Parameter | Name:
C01300 | Profile data: Positioning mode
Data type: UNSIGNED_8
Index: 23275
d
= 5AEB
h
Selection of the positioning mode for profiles 1 ... 15
 Profile entry
Selection list Info
1 Absolute (shortest path) Absolute positioning
• The profile position corresponds to the target
position.
2 Continuous Continuous positioning without approaching a target
position
3 Relative Relative positioning
• The profile position determines the distance to be
traversed.
4 absolute (Cw) Clockwise absolute positioning
• The zero position of the axis can be exceed in this
direction.
• The profile position corresponds to the target
position.
5 absolute (Ccw) Counter-clockwise absolute positioning
• The zero position of the axis can be exceed in this
direction.
• The profile position corresponds to the target
position.
8 Absolute (shortest path) to TP Absolute positioning
• The profile position corresponds to the target
position.
• After a touch probe is detected, the TP profile
( C01308/1...15 ) is executed.
9 Continuous to TP Continuous positioning without approaching a target
position
• After a touch probe is detected, the TP profile
( C01308/1...15 ) is executed.
10 Relative to TP Relative positioning
• The profile position determines the distance to be
traversed.
• After a touch probe is detected, the TP profile
( C01308/1...15 ) is executed.
11 Absolute (Cw) on TP Clockwise absolute positioning
• The zero position of the axis can be exceed in this
direction.
• The profile position corresponds to the target
position.
• After a touch probe is detected, the TP profile
( C01308/1...15 ) is executed.
12 Absolute (Ccw) on TP Counter-clockwise absolute positioning
• The zero position of the axis can be exceed in this
direction.
• The profile position corresponds to the target
position.
• After a touch probe is detected, the TP profile
( C01308/1...15 ) is executed.
Subcodes Lenze setting Info
C01300/1 1: absolute (beeline) Profiles 1 ... 15: Positioning mode
C01300/...
C01300/15
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1