Lenze 8400 TopLine - Manual (Page 589)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
589
9 Basic drive functions (MCK)
9.4 Basic settings
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.4.2 Min/Max speed
For the " Speed follower " operating mode, yo can initially limit the speed setpoint by means of the
following parameters:
In the »Engineer», you can set the initial limit by means of the dialog box Min/Max speed.
• Open the Min/max speed dialog box by opening the Application Parameters tab and clicking on
the following button on the dialog level Overview  Signal flow:
Speed setpoint generation
When the speed limit values are set, the Motion Control Kernel influences the setpoint generation
with a synchronisation mode The synchronisation mode serves to travel the synchronisation range
dynamically with the synchronisation ramp set in C02610/2 . Synchronisation always starts in the
zero crossing of the defined speed.
[9-14] Example: Speed setpoint generation in the "Speed follower" operating mode (with nSpeedAddValue_v = 0)
Parameter Info Lenze setting
Value Unit
C02610/2 MCK: Ramp time synchr. setpoint 2.000 s
C02611/1 MCK: Pos. max. speed 199.99 %
C02611/2 MCK: Pos. min. speed 0.00 %
C02611/3 MCK: Neg. min. speed 0.00 %
C02611/4 MCK: Neg. max. speed 199.99 %
 Setpoint range
 Synchronisation range
Sync
Sync
v
t
C02611/1
C02611/2
C02611/3
C02611/4
C02610/2
0
1
0
nSpeedSetValue_a nSpeedSetValue_a_
C02610/2