Lenze 8400 TopLine - Manual (Page 725)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
725
10 Diagnostics & error management
10.9 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Ck02: Neg. HW limit switch [xx.0184.00002]
Ck15: Error status sign. brake [xx.0184.00005]
Ck03: Pos. SW limit position [xx.0184.00007]
Ck04: Neg. SW limit position [xx.0184.00008]
Ck14: Target position outside SW limit position [xx.0184.00015]
Response (Lenze setting printed in bold) Setting: C00595/2 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: The hardware limit switch in negative traversing
direction has tripped.
• The bLimitSwitchNeg input for travel range
monitoring via negative hardware limit switch has
been set to FALSE (fail-safe).
Reset error message and retract limit switch.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: The status monitoring of the holding brake control
has tripped.
• Check configuration of the bMBrakeApplied input for
status detection of the brake (via a switching contact
at the brake).
• Check wiring/function of the switching contact.
• Adapt waiting time ( C02589/3 ).
• Deactivate status monitoring (via bit 5 in C02582 ).
Response (Lenze setting printed in bold) Setting: C00595/3 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: The device has detected that the position is outside
the positive software limit position ( C01229/1 ).
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate software limit position monitoring.
Response (Lenze setting printed in bold) Setting: C00595/4 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: The device has detected that the position is outside
the negative software limit position ( C01229/2 ).
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate software limit position monitoring.
Response (Lenze setting printed in bold) Setting: C00595/14 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
MCK: It has been attempted to position a target outside
the software limit positions ( C01229/1 and C01229/2 ).
• Select a target within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate software limit position monitoring.