Lenze 8400 TopLine - Manual (Page 1263)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
1263
17 Parameter reference
17.2 Parameter list | C02314
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02314
C02315
C02430
Parameter | Name:
C02314 | Reserved
Data type: UNSIGNED_8
Index: 22261
d
= 56F5
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C02315 | LS_WriteParamList: Manual entry of motor type
Data type: UNSIGNED_8
Index: 22260
d
= 56F4
h
From version 14.00.00 onwards : Parameter values (1st value ... 4th value) for optional motor data change-over
Selection list
0 Automatic
1 ASM
2 PSM
Subcodes Lenze setting Info
C02315/1 0: Automatic LS_WriteParamList : c1001_s1_val1
C02315/2 0: Automatic LS_WriteParamList : c1001_s1_val2
C02315/3 0: Automatic LS_WriteParamList : c1001_s1_val3
C02315/4 0: Automatic LS_WriteParamList : c1001_s1_val4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C02430 | Axis bus address and no. of nodes
Data type: UNSIGNED_8
Index: 22145
d
= 5681
h
From version 02.00.00
 Data transfer axis bus
Setting range (min. value | unit | max. value)
0 62
Subcodes Lenze setting Info
C02430/1 0 Axis bus address
• 0 ≡ Node is disconnected from the axis bus
• 1 ≡ Master
• 2 ... 62 ≡ slave 1 ... slave 61
C02430/2 2 Axis bus no. of nodes
• Number of slaves connected to the axis bus.
• Setting only required for the master.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1