Apple Motion 3 - Manual (Page 961)

Chapter 10 Using Filters 961
Parameters in the Inspector
Strobe Rate: Sets the number of frames of each strobe. Values range from 1 to 60.
Mix: Sets the amount of the filtered frame to be mixed with the original source frame.
Values range from 0 to 100%.
HUD Controls
The HUD contains the Strobe Duration control.
Trails
Draws light or dark trails following an object’s movement. This filter is only effective
with moving images.
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Duration: Sets the duration of the trails. Values range from 0 to 1.00.
Echoes: Sets the number of echoes trailing behind. Values range from 1 to 30.
Decay: Toggles whether the trails decay over time or disappear at the end of the
duration.
Trail On: Sets the kind of values that trigger the trails. This can be set to Light or Dark.
Mix: Sets the amount of the filtered frame to be mixed with the original source frame.
Values range from 0 to 100%.
HUD Controls
The HUD contains the same controls as the Inspector, with the exception of the Mix
control.
Original image Decay is turned on, and Trail On is set to Light.