Apple Motion 3 - Manual (Page 745)

Chapter 8 Working with Particles 745
Note: If you do not have any additional images in your project, you can create them in
the project or search the Content category in the Library for images.
Next, drag the new layer either onto the emitter, or below it (but not onto an existing
cell). This example uses the “Spark12.png” file, also located in the Content folder in the
Library.
This results in the following image:
4 To make the particles generated by each different cell mingle together, turn on the
Interleave Particles parameter in the Emitter tab of the Inspector.
5 Select the Flare01 cell in the Layers tab, then set the Scale slider in the Particle Cell tab
of the Inspector to 15%.
Doing this reduces the size of the particles generated by this cell.
6 Select the Spark12 cell in the Layers tab, then set the Scale slider in the Inspector to
45%.