Apple Motion 3 - Manual (Page 873)

Chapter 10 Using Filters 873
Parameters in the Inspector
Red – Red: Sets the amount of input red added to the output red. The default value is
1.0, which leaves the red channel unmodified. As this value increases, the output value
of red increases by the amount of input red multiplied by the value of Red – Red.
Values range from –2 to 2.
Red – Green: Sets the amount of input green added to the output red. The default
value is 0, which leaves the red channel unmodified. As this value increases, the output
value of red increases by the amount of input green multiplied by the value of Red –
Green. Values range from –2 to 2.
Red – Blue: Sets the amount of input blue added to the output red. The default value
is 0, which leaves the red channel unmodified. As this value increases, the output value
of red increases by the amount of input green multiplied by the value of Red – Blue.
Values range from –2 to 2.
Red – Alpha: Sets the amount of input alpha added to the red channel. The default
value is 0, which leaves the red channel unmodified. As this value increases, the value
of red increases by the amount of input alpha multiplied by the value of Red – Alpha.
Values range from –2 to 2.
Green – Red: Sets the amount of input red added to the output green. The default
value is 0, which leaves the green channel unmodified. As this value increases, the
output value of green increases by the amount of input red multiplied by the value of
Green – Red. Values range from –2 to 2.
Green – Green: Sets the amount of input green added to the output green. The
default value is 1.0, which leaves the green channel unmodified. As this value increases,
the output value of green increases by the amount of input green multiplied by the
value of Green – Green. Values range from –2 to 2.
Green – Blue: Sets the amount of input blue added to the output green. The default
value is 0, which leaves the green channel unmodified. As this value increases, the
output value of green increases by the amount of input blue multiplied by the value of
Green – Blue. Values range from –2 to 2.
Green – Alpha: Sets the amount of input alpha added to the green channel. The
default value is 0, which leaves the green channel unmodified. As this value increases,
the value of green increases by the amount of input alpha multiplied by the value of
Green – Alpha. Values range from –2 to 2.
Blue – Red: Sets the amount of input red added to the output blue. The default value
is 0, which leaves the blue channel unmodified. As this value increases, the output
value of blue increases by the amount of input red multiplied by the value of Blue –
Red. Values range from –2 to 2.