Apple Motion 3 - Manual (Page 907)

Chapter 10 Using Filters 907
Parameters in the Inspector
Center: Sets the position of the origin of the effect.
Amplitude: Sets the width of the waves. Values range from 0 to 100.
Crop: Toggles whether the object is cropped at its original boundaries.
Mix: Sets what percentage of the original image is blended with the filtered image.
Values range from 0 to 100%.
HUD Controls
The HUD contains the Amplitude control.
Scrape
Smears an image along an angle defined by the Rotation parameter. The Scrape effect
starts at the center point, and continues to the edge of the object.
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Center: Sets the position of the center of the scrape.
Rotation: Sets the angle of rotation of the scrape.
Amount: Sets the ramping of the number of pixels spread across the range of the
scrape. Values range from 0 (very gradual) to 200 (hard edge).
Mix: Sets what percentage of the original image is blended with the filtered image.
Values range from 0 to 100%.
HUD Controls
The HUD contains the Rotation and Amount controls.
Original image Scrape applied