Apple Motion 3 - Manual (Page 886)

886 Chapter 10 Using Filters
White In: Sets the In point for white, above which values will not be output.
White Out: Sets the maximum brightness value that appears in the output. Other
values are scaled between Black Out and White Out values.
Gamma: Sets the amount of gamma correction. This parameter ranges from 0 to 5.00.
Mix: Sets what percentage of the original image is blended with the filtered image.
Values range from 0 to 100%.
HUD Controls
There are no controls for this filter in the HUD.
Negative
Simulates the effect of turning an image into a film negative. This filter causes
rasterization in 3D groups.
There are no parameters for this filter.
HUD Controls
There are no controls for this filter in the HUD.
Reduce Banding
Reduces the amount of banding in the image.
Parameters in the Inspector
Noisiness: Sets the amount of noise to introduce into the object, ranging from -0.0 (no
noise) to 100.0 (maximum noise).
Movement: Sets whether or not to animate the noise in the image.
Mix: Sets the amount of the original image to mix with the filtered image.
HUD Controls
The HUD contains the Noisiness control.
Original image Negative applied