Apple Motion 3 - Manual (Page 864)

864 Chapter 10 Using Filters
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Point 1: Sets the position of the first point of the gradient.
Point 2: Sets the position of the second point of the gradient.
Amount: Sets the radius of the blur.
Crop: Sets whether or not the object is cropped at its original boundaries.
HUD Controls
The HUD contains the Amount and Crop controls.
Movement Blur
Analyzes movement in a clip using optical flow methods, blurs the movement, and
mixes the result with the original image.
This filter causes rasterization in 3D groups.
Parameters in the Inspector
Amount: Sets the radius of the blur. Values range from 0 to 10.
Sensitivity: Sets the sensitivity of blur detection. The higher the value, the lower the
threshold of movement required to result in motion blur. Values range from 0 to 1.
Quality: Sets the quality of the blur calculations. A higher values increases the quality
of the resulting blur. Values range from 1 to 10.
Smoothness: Sets the smoothness of the blur. Values range from 0 to 10.
Original image Point 1 upper left, Point 2 lower right