Lenze E94A - Manual (Page 315)

Lenze · 9400 function library · Reference manual · DMS 6.7 EN · 08/2014 · TD05
315
5 Function blocks
5.86 L_LdConvAxisV - speed ratio
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.86 L_LdConvAxisV - speed ratio
This FB transforms a speed between two axes.
Inputs
Outputs
Function library: LenzeLineDrive
Runtime software licence:  Motion Control HighLevel  Motion Control TopLevel
Identifier/data type Information/possible settings
bEnable
BOOL
Activate function
FALSE Output speed = "0".
TRUE Output speed = transformed input speed.
dnSpeedIn_s
DINT
Selection of the master speed
• At this input, the FB expects a speed in [rpm]. The machine parameters at the in-
put XAxisData are used as speed reference.
• C05165/1 indicates the master speed in the real unit of the machine.
XAxisData Machine parameters for scaling the master speed (master shaft)
• The machine parameters of a master drive can be displayed with the
FB L_SdSetAxisData . In this case, the FB output AxisData must be connected to
this input. ( 510)
YAxisData Machine parameters for scaling the setpoint speed (tool)
• For accepting the machine parameters of the drive/motor, connect this input
with the output DI_AxisData of the SB LS_DriveInterface.
Identifier/data type Value/meaning
dnState
DINT
Status (bit coded)
bits14 Internal limitation for calculation
Bit15 Error
bits23 No valid axis data structure
dnSpeedOut_s
DINT
Setpoint speed output in [rpm]
• C05165/2 indicates the setpoint speed in the real unit of the machine.
GQ6WDWH
GQ6SHHG2XWBV
/B/G&RQY$[LV9
;$[LV'DWD
<$[LV'DWD
E(QDEOH
GQ6SHHG,QBV
<
;
&
&RXSOHPHDVXULQJV\VWHP;DQG<
<
;
<
;
&RXSOLQJYLD
F\FOHV
&RXSOLQJYLD
IHHGFRQVWDQW
)UHHFRXSOLQJ
& &