Lenze E94A - Manual (Page 279)

Lenze · 9400 function library · Reference manual · DMS 6.7 EN · 08/2014 · TD05
279
5 Function blocks
5.74 L_DevReadParDInt - reading parameters of the DINT type
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C05914 0.000 s 10.000 Time-out time
• Time in which the read request
must have been processed.
• Initialisation: 0.000 s
C05915 0.000 s 100.000 Cycle time
• Interval for the cyclic reading of a
parameter.
• Initialisation: 0.000 s
(cyclic reading is deactivated)

Note!
The cycle time set in C05915 applies only to the use of the FB in a 1-ms task! For a longer
task cycle the cycle time is prolonged accordingly:
If the FB is used in the unsolicited task, the cycle time set is not effective. In this case use
an upstream FB L_TbOscillator instead, in order to cyclically trigger the read request:
• Connect the output bOut of FB L_TbOscillator with the input bExecute.
• Set the desired cycle time via the parameters of the FB L_TbOscillator .
Parameter Possible settings Info
Cycle time
C5915 [s] Task cycle [ms] ⋅
1 [ms]
------------------------------------------------------------------- =