Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 97)

L
Firmware 1.37 - 09/2006 97
9400 HighLine | Parameter setting & configuration
Motor interface
Parameter setting
5.4 Parameter setting
Short overview of the other parameters for the motor interface:
Parameters Information
C00050/1 Speed setpoint 1
C00050/2 Speed setpoint 2
C00051 Actual speed
C00052 Motor voltage
C00054 Motor current
C00055/1 Phase current - phase zero system
C00055/2 Phase current - phase U
C00055/3 Phase current - phase V
C00055/4 Phase current - phase W
C00056 Torque setpoint
C00057/1 Maximum torque
C00057/2 Torque at maximum current
C00059 Motor - number of pole pairs
C00060 Rotor position
C00063 Motor temperature
C00066 Thermal motor load (I 2 xt)
C00120 Motor overload protection (I 2 xt)
C00121 Warning threshold - motor temperature
C00127 Warning threshold - motor overload
C00583 Response to motor KTY overtemperature
C00584 Response to motor temperature > C00121
C00585 Response to motor PTC overtemperature
C00606 Resp. to motor overload
C00909/1 Upper speed limit value
C00909/2 Lower speed limit value
C02527 Motor mounting direction
C02550/1 Position setpoint interpolation
C02550/2 Speed setpoint interpolation
C02550/3 Torque setpoint interpolation
C02553 Position controller gain
C02554 Position controller reset time
C02555 Position controller D component
C02556 Pos. contr. limitation
C02557 Motor position controller output
C02558 Position controller output
C02559/1 Upper int. torque limit
C02559/2 Lower int. torque limit
C02560 Messages motor interface
C02567 Control mode
Highlighted in grey = display parameter