Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 468)

9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
468 Firmware 1.37 - 09/2006
L
Control card is defective (UB18 neg.) [0x00780008]
Control card is defective (VCC5) [0x00780009]
Electronic nameplate: Data incompatible [0x0078000a]
Device command transmitted incorrectly [0x00790000]
Time error - controller interface [0x00790001]
Violation of the time dial [0x00790002]
Motor: Calculated motor impedance unrealistic [0x007b0001]
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
The connected motor with feedback is not supported by
the controller firmware.
Check drive dimensioning.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning : Information
Cause Remedy
Faulty motor parameterisation. Check motor parameters.