Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 67)

L
Firmware 1.37 - 09/2006 67
9400 HighLine | Parameter setting & configuration
Motor interface
Initial commissioning | Display/edit motor data in the »Engineer«
5.1.3 Display/edit motor data in the »Engineer«
The "Motor data" only summarises the parameters which depend on the motor. These only
characterise the electrical behaviour of the machine.
r The motor data do not depend on the application in which the controller and motor are
used.
r The motor data are, if available in the »Engineer« via electronic nameplate or motor
catalog, accepted by the controller without confirmation prompt.
In the »Engineer«, the motor data are indicated on the Application parameters tab, dialog
level OverviewMotor:
r If you use a motor of a third-party manufacturer, the displayed motor data can be
adapted exactly to the existing motor by selecting the entry "Own motor settings" in
the list field Motor selection.
r Click From Motor catalog to open the motor catalog and select a different motor.
Read the motor data out of the controller
(C 66)
r Click From controller to accept the motor data set in the controller while being online
in the »Engineer«. Read the motor data out of the controller
(C 66)