Speed has been limited [0x00b8000b, 9400 highline | parameter setting & configuration – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 534
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
534
Firmware 1.37 - 09/2006
L
Positive software limit switch has been overtravelled [0x00b80007]
Negative software limit switch has been overtravelled [0x00b80008]
Positive direction of rotation has been limited [0x00b80009]
Negative direction of rotation has been limited [0x00b8000a]
Speed has been limited [0x00b8000b]
Response (Lenze setting printed in bold)
Setting:
;
None System fault ; Fault ; Trouble : Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
The positive software limit position parameterised in
has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Response (Lenze setting printed in bold)
Setting:
;
None System fault ; Fault ; Trouble : Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
The negative software limit position parameterised in
has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Response (Lenze setting printed in bold)
Setting:
:
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
Due to the setting of
it was tried to traverse in
the impermissible positive direction of rotation.
• Only traverse in permissible (negative) direction of
rotation.
• Change setting of the permissible direction of
rotation (
).
Response (Lenze setting printed in bold)
Setting:
:
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
Due to the setting of
it was tried to traverse in
the impermissible negative direction of rotation.
• Only traverse in permissible (positive) direction of
rotation.
• Change setting of the permissible direction of
rotation (
).
Response (Lenze setting printed in bold)
Setting:
:
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
The requested profile speed is higher than the maximum
and has been limited to this speed.
• Reduce speed of the traversing profile of the basic
function (manual jog, referencing or positioning).
• Increase maximum speed (
).
• Deactivate monitoring of the limit values by the basic
function "Limiter".