Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 467)

L
Firmware 1.37 - 09/2006 467
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
Motor load I²xt > C00127 [0x00780002]
Motor load I²xt > C00120 [0x00780003]
Control card is defective (UB24) [0x00780004]
Control card is defective (VCC15) [0x00780005]
Control card is defective (UB8) [0x00780006]
Control card is defective (VCC15 neg.) [0x00780007]
Response (Lenze setting printed in bold) Setting: C00606 (; Adjustable response)
; None System fault ; Fault Trouble Quick stop by trouble Warning locked : Warning Information
Cause Remedy
Motor is thermally overloaded, e.g. due to:
• impermissible continuous current
• frequent or too long acceleration
• Check drive dimensioning.
• Check setting under C00127 .
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Motor is thermally overloaded, e.g. due to:
• impermissible continuous current
• frequent or too long acceleration
• Check drive dimensioning.
• Check setting under C00120 .
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Device error Please contact Lenze.