2 status display for device command, Indicated, Status display for device command – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 54: C 54), 9400 highline | parameter setting & configuration
![background image](/manuals/566320/54/background.png)
9400 HighLine | Parameter setting & configuration
Drive interface
Controller commands
54
Firmware 1.37 - 09/2006
L
4.6.2
Status display for device command
indicates the number and the status of the last executed controller command. The
number of the controller command is indicated in the upper 16 bits and the execution
status in the lower 16 bits.
r
The following table lists the most important status messages according to the degree
of probability of their occurrence.
1021 Export parameter to file
Export current parameter set to file.
z
1030 Format file system
Format file system of the memory module.
z
1040 Restore file system
-
10000 Prepare firmware update
z
11000 Restart controller
z
Controller command
Information
Status*
The device command status is displayed in
C00003
.
Status display for device command
C00003
Bit 16 ... 31
Bit 0 ... 15
Device command executed last
Status of the last executed controller command
Bit 0 ... 15
Status
Concerns device
command
0x0000
Execution ok.
All
0x0001
General fault.
All
0x8404
File could not be opened.
201, 202, 203, 204,
301, 302, 303, 304
0x841D
Fault while reading out of a file.
201, 202, 203, 204,
301, 302, 303, 304
0x841E
Fault while writing into a file.
11,
201, 202, 203, 204,
301, 302, 303, 304
0x841F
Invalid file type.
201, 202, 203, 204,
0x8420
Unexpected file end.
201, 202, 203, 204,
301, 302, 303, 304
0x8422
Checksum error
201, 202, 203, 204
0x842B
Fault while reading the parameter set partition.
1
0x842C
Fault while writing the parameter set partition.
11
0x842E
No memory module available.
1, 11
0x8502
Processing of the device command is still active.
All
0x9Axx
CAN fault
0, 1, 5,
91, 92,
201, 202, 203, 204
0x9B07
Rotor position adjustment cannot be executed because of the wrong
motor type (asynchronous motor).
51
0x9B08
Rotor position adjustment has been aborted.
51
0x9B09
Rotor position adjustment cannot be executed since another
identification is active already.
51
0x9B0A
Rotor position adjustment cannot be executed since the V/f-test
mode is active.
51