Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 319)

L
Firmware 1.37 - 09/2006 319
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Electronic gearbox" | Quick stop
12.2.10 Quick stop
[12-20] Basic function "Quick stop" (schematic diagram)
r The quick stop function can be activated as follows in the Lenze setting:
– By setting the digital input DI1 to LOW level.
– By a master control via the port LPortControl1:
By setting bit 2 of the bit-coded control word 1.
r Parameter setting: Tab Application parameter Dialog level Overview All basic
functions Quick stop
O
Tip!
Detailed information on quick stop can be found in chapter "Basic drive functions"
subchapter " Quick stop ".
(C 152)
The basic function "Quick stop" brakes the
drive to standstill within the deceleration
time set for the quick stop function after a
corresponding request independent of the
setpoint selection.
If the quick stop function is deactivated,
the drive is led to the selected setpoint
again via the set acceleration time.
v
t t
M
Slave
n
t
LS_Limiter
n
t
LS_Quickstop
STOP
Parameters Lenze setting
Value Unit
C00105 Quick stop deceleration time 0.000 s
C00106 Quick stop S-ramp time 0.00 %
C00107 Reference for deceleration time "Quick stop" Motor reference speed ( C00011 )
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
DigIn 1 Activate quick stop 1 C03135/1
Control word 1
bit 02
Activate quick stop 2 C03135/2
FALSE Activate quick stop 3 C03135/3