Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 233)

L
Firmware 1.37 - 09/2006 233
9400 HighLine | Parameter setting & configuration
Technology applications (TAs)
Overview
10 Technology applications (TAs)
Technology applications are block applications with parameter setting interface prepared
by Lenze which form the basis of solving typical applications.
Delivery
The technology applications available for the 9400 Servo Drives can be selected in the
»Engineer« from the application catalog.
Commissioning
Commissioning is carried out D with the »Engineer« by selection from the catalogue,
transmission to the controller, and parameter setting via corresponding dialogs.
Commissioning using the »Engineer«
(C 235)
Licensing
Technology applications require a runtime software license which is determined by the
plugged memory module and is higher or equal to the required license.
[10-1] Indication of the runtime software license in the designation of the memory module
10.1 Overview
License Controller
1 Motion Control StateLevel 9400 StateLine
2 Motion Control HighLevel 9400 HighLine
3 Motion Control TopLevel 9400 HighLine
4 PLC 9400 HighLine
MM
Technology application/application ranges Required license/delivery
TA "Actuator – speed" (C 244)
• General servo drive for speed control of:
–Conveyor drives (connected in one system)
–Extruder
–Test benches
–Vibrators
–Travelling drives
–Presses
–Machine tools
–Dosing machines
• Actuating drives for master control
–Positioning drives with external position control
–Multi-axis systems with external path control
Available in every license stage.
The technology application can be
selected in the »Engineer«
application catalog.