Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 26)

9400 HighLine | Parameter setting & configuration
Commissioning
26 Firmware 1.37 - 09/2006
L
3 Commissioning
This documentation contains detailed information on parameter setting and
configuration of the controller. Sequential reading is not required.
In order to get the information relevant for an initial commissioning, this chapter describes
different commissioning scenarios which can also be used as a guide through this Manual:
A. Test commissioning
(C 28)
– Target: Rotating the motor with as few settings as possible in best time.
B. Initial commissioning
(C 29)
– Target: Adapting the controller to electromechanics and control.
C. Standard set-up
(C 31)
– Target: Taking over the application and parameter set of an already preconfigured
"Engineer" project in several controllers.
D. Controller replacement
(C 32)
– Target: Replacing a controller which has failed in a running system by a replacement
device using the "old" memory module.
E. Motor replacement
(C 33)
– Target: Replacing a motor which has failed in a running system.