Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 537)

L
Firmware 1.37 - 09/2006 537
9400 HighLine | Parameter setting & configuration
Parameter reference
Structure of the parameter descriptions
16 Parameter reference
All parameters for controller parameter setting or monitoring are stored within so-called
"codes".
r The codes are numbered and designated by a "C" in front of the code, e.g. "C00002".
r For the sake of clarity, some codes contain "subcodes" for saving parameters. This
Manual uses a slash "/" as a separator between code and subcode, e.g. C00118/3".
O
Tip!
For quick reference of a parameter with a certain name simply use the index of the
online documentation. The index always contains the corresponding code in
parentheses behind the name.
For general information on how to read and change parameters please see the
online documentation for the »Engineer«.
16.1 Structure of the parameter descriptions
Each parameter is described in the Parameter list in the form of a table which consists of
the following three areas:
Table header
The table header contains the following general notes:
r Parameter number (Cxxxxx)
r Parameter name (display text in the »Engineer» and keypad)
r Data type
r Decimal and hexadecimal parameter index for access via bus systems
Table contents
The table contains further general explanations & notes on the parameter and the possible
settings the representation of which depends on the parameter type:
r Parameters with read-only access
r Parameters with write access
Table footer
The table footer contains the
Parameter attributes .
16.1.1 Data type
The following data types are available for parameters: