Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 192)

9400 HighLine | Parameter setting & configuration
Basic drive functions
Speed follower | Parameter setting
192 Firmware 1.37 - 09/2006
L
9.8.2 Parameter setting
r Parameterisation dialog in the »Engineer«: Tab Application parameter dialog level
Overview All basic functions Speed follower
r Short overview of the parameters for the speed follower:
Parameters Information
C00050/1 Speed setpoint 1
C00070 Speed controller gain
C00071 Speed controller reset time
C00072 D component - speed controller
C00273/1 Motor moment of inertia
C00273/2 Load moment of inertia
C00276 Signal source torque setpoint
C00576 Window - speed monitoring
C00579 React. speed monitoring
C00909/1 Upper speed limit value
C00909/2 Lower speed limit value
C02520 Gearbox fact. numer. motor
C02521 Gearbox fact. denom. motor
C02522 Gearbox fact. numer. load
C02523 Gearbox fact. denom. load
C02527 Motor mounting direction
C02531/3 Resulting gearbox factor - motor/load
C02550/2 Speed setpoint interpolation
C02550/3 Torque setpoint interpolation
C02570 Controller configuration
C02559 Internal torque limit
Highlighted in grey = display parameter