Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 535)

L
Firmware 1.37 - 09/2006 535
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
Acceleration has been limited [0x00b8000c]
Deceleration has been limited [0x00b8000d]
Jerk has been limited [0x00b8000e]
Position target is outside software limit positions [0x00b8000f]
Response (Lenze setting printed in bold) Setting: C02716/3 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The requested profile acceleration is higher than the
maximum acceleration set in C02705 and has been
limited to this acceleration.
• Reduce acceleration of the traversing profile of the
basic function (manual jog, referencing or
positioning).
• Increase maximum acceleration ( C02705 ).
• Deactivate monitoring of the limit values by the basic
function "Limiter".
Response (Lenze setting printed in bold) Setting: C02716/3 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The requested profile deceleration is higher than the
maximum acceleration set in C02705 and has been
limited to this acceleration.
• Reduce acceleration of the traversing profile of the
basic function (manual jog, referencing or
positioning).
• Increase maximum acceleration ( C02705 ).
• Deactivate monitoring of the limit values by the basic
function "Limiter".
Response (Lenze setting printed in bold) Setting: C02716/3 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The requested S-ramp time is lower than the minimum
S-ramp time set in C02706 and has been limited to this S-
ramp time.
• Increase S-ramp time of the traversing profile of the
basic function (manual jog, referencing or
positioning).
• Reduce minimum S-ramp time ( C02706 ).
• Deactivate monitoring of the limit values by the basic
function "Limiter".
Response (Lenze setting printed in bold) Setting: C02716/2 (; Adjustable response)
; None System fault ; Fault ; Trouble : Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
It was tried to position to a target outside the software
limit positions.
• Select position target inside the software limit
positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".