Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 457)

L
Firmware 1.37 - 09/2006 457
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
Internal error (event mechanism) [0x00690009]
Internal error (event mechanism) [0x0069000a]
Internal error (semaphores) [0x0069000b]
Internal error (faulty binary semaphores) [0x0069000c]
Internal error (file system) [0x0069000d]
General application error [0x006a0000]
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Serious device error or component failure. Switch off and on controller.
• Please contact Lenze, if the problem occurs again.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Serious device error or component failure. Switch off and on controller.
• Please contact Lenze, if the problem occurs again.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Serious device error or component failure. Switch off and on controller.
• Please contact Lenze, if the problem occurs again.
Response (Lenze setting printed in bold)
None : System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
Serious device error or component failure. Switch off and on controller.
• Please contact Lenze, if the problem occurs again.
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked : Warning Information
Cause Remedy
In case of the memory module the maximum number of
permissible writing cycles has been reached.
Exchange memory module, otherwise data may get lost.
Response (Lenze setting printed in bold)
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause Remedy
General application error. Mains switching. Transmit the application to the
controller again.
• Please contact Lenze, if the problem occurs again.