IAI America XSEL-S - Manual (Page 476)

Chapter 7
Troubleshooting
7.3 Error List (MAIN application)
468
In the panel window, the error numbers follow E in the display.
Error
No.
Error name Description, action, etc.
A85 FROM write request error before
erase is complete
When updating, a flash-ROM write command was received
before a flash-ROM erase command.
Confirm that the update program file is valid and then
perform update again.
A86 Absolute-encoder backup battery
voltage-low warning (Driver
detection)
The voltage of the absolute-data backup battery is low.
Check the battery connection or replace the battery.
A87 Motorola S-byte count error (Core
detection)
The update program file is invalid. Check the file.
A88 Message conversion error (Core
detection)
The received message does not conform to the message
format or contains invalid data.
Check the message sent from the host communication
device.
A89 Updating target non-specification
error (Core detection)
During update, an update command was received before
the updating target was specified properly.
Check if an appropriate updating PC tool is used and the
target specification and other settings in the updating PC
tool are correct.
A8A Updating system code error (Core
detection)
The system code in the message received with the
updating target specification command does not match the
controller system.
Check the target specification and other settings in the
updating PC tool.
A8B Updating unit code error (Core
detection)
The unit code in the message received with the updating
target specification command does not match any
updatable unit in the controller.
Check the target specification and other settings in the
updating PC tool.
A8C Updating device number error
(Core detection)
The specified device number in the message received with
the updating target specification command is not
appropriate.
Check the target specification and other settings in the
updating PC tool.
A8D Flash busy reset timeout (Core
detection)
Error erasing/writing the flash ROM
M
es
sa
ge
le
ve
l e
rro
rs
A8E Unit type error (Detection in core
area)
The unit type in command receiving message is in an error
or a type that is not supported.