IAI America XSEL-S - Manual (Page 302)

Chapter 6 Parameter
6.1 I/O Parameter (All types)
294
I/O Parameter (All types)
No. Parameter name
Default
value
(reference)
Input
range
Unit Remarks
124 Network attribute 5 0H
0H to
FFFFFFFFH
EtherNet TCP/IP message communication
attribute
Ethernet client/server type
(0: Not in use
1: Client (Automatic assignment of own port
number)
2: Client (Specification of own port number)
� This setting is not recommended because
of device limitations, such as an error
generation when the port is opened for
approx. 10 minutes after disablement of
close response check due to a power
failure at the connection destination, etc.)
3: Server (Specification of own port number))
* Note: Number of clients that can be connected
simultaneously to one server port channel
= 1
Bits 0 to 3: IAI protocol B/TCP (MANU mode)
* PC software can be connected
only in the case of a client.
Bits 4 to 7: IAI protocol B/TCP (AUTO mode)
* PC software can be connected
only in the case of a client.
Bits 8 to 11: Channel 31 opened to user
Bits 12 to 15: Channel 32 opened to user
Bits 16 to 19: Channel 33 opened to user
Bits 20 to 23: Channel 34 opened to user
* If the parameter settings for own port number,
client/server type, IP address of connection
destination and port number of connection
destination do not match completely between the
IAI protocol B/TCP MANU and AUTO modes, the
connection will be cut off when the MANU/AUTO
mode is switched.
125 Network attribute 6 31E32H
0H to
FFFFFFFFH
Bits 0 to 7: System Reservation
Bits 8 to 15: System Reservation
Bits 16 to 23: Increment of “PC/TP reconnection
delay at software reset” when
Ethernet is used (sec)
126 Network attribute 7 7D007D0H
0H to
FFFFFFFFH
System Reservation
127 Network attribute 8 5050214H
0H to
FFFFFFFFH
EtherNet TCP/IP message communication
attribute
Bits 0 to 7: CONNECT_TIMEOUT
(Change is prohibited)
(Setting of “0” is prohibited) (sec)
Bits 8 to 15: Connection retry interval
(IAI protocol B/TCP) (sec)
Bits 16 to 23: Send timeout value (sec)
Bits 24 to 31: IAI protocol B-SIO
non-communication check timer
setting (sec)
(IAI protocol B/TCP connection
trigger)
128 Network attribute 9 10000H
0H to
FFFFFFFFH
EtherNet TCP/IP message communication
attribute
Bits 0 to 15: SEL server open timeout value
(sec)
(No timeout check when “0” is set)
Bits 16 to 23: Change Prohibited
129 Network attribute 10 0
0H to
FFFFFFFFH
EtherNet operation requirement
Bits 0 to 3: System Reservation
Bits 4 to 7: TCP/IP message communication
(0: Not in use, 1: Use)
Bits 8 to 31: Reserved (Operation requirement)
130 Network I/F Module 1
Own MAC address (H)
0H
Referenceonly
(HEX)
Only lower two bytes are valid.