IAI America XSEL-S - Manual (Page 467)

Chapter 7
Troubleshooting
7.3 Error List (MAIN application)
459
In the panel window, the error numbers follow E in the display.
Error
No.
Error name Description, action, etc.
D5A Fieldbus error (TOGGLE timeout) A TOGGLE timeout was detected.
Check the statuses of monitor LEDs on the front panel of
the board by referring to the operation manual for the field
network board.
D5B Fieldbus error (Access-privilege
retry over)
An access-privilege retry over error was detected.
Check the statuses of monitor LEDs on the front panel of
the board by referring to the operation manual for the field
network board.
D5C Fieldbus error (Access-privilege
open error)
An access-privilege open error was detected.
Check the statuses of monitor LEDs on the front panel of
the board by referring to the operation manual for the field
network board.
D5D Fieldbus error (FBRS link error) A FBRS link error was detected.
Check the statuses of monitor LEDs on the front panel of
the board by referring to the operation manual for the field
network board.
D5E Fieldbus error (Mailbox response) A mailbox response error was detected.
Check the statuses of monitor LEDs on the front panel of
the board by referring to the operation manual for the field
network board.
D5F Network I/F Module Class
Mismatch error�
The type of I/F module specified in I/O parameter No. 225
and the type of network module actually mounted do not
match.
�
Check the setting in I/O parameter No. 225 and the
combination of network I/F module actually mounted.�
D60 Expanded-SIO 2/4 CH insulation
power error
An Expanded-SIO insulation power error was detected.
D61 Expanded-SIO 1/3 CH insulation
power error
An Expanded-SIO insulation power error was detected.
D62 Expanded-SIO
baud-rate-generator clock
oscillation error
An Expanded-SIO clock oscillation error was detected.
D63 Expanded-SIO UART paging error An Expanded-SIO paging error was detected.
D64 Expanded-SIO assignment error The “board channel assignment number” or “expanded-I/O
slot assignment number” in I/O parameter Nos. 100, 102,
104, 106, 108 or 110 may be outside the input range or
duplicated, a serial communication expansion board may
not be installed in the specified slot, or a “communication
mode” other than RS232C may have been selected when
the “board channel assignment number” is other than “1” or
“2,” among other reasons.
D65 Power supply board mismatch
error
The inserted power supply board (standard / high capacity)
does not match with that set in the parameter.
D66 In-rush current control circuit error The in-rush current control relay is not working properly
even though the power is turned on.
D67 Motor/encoder configuration
information mismatch error
The “motor/encoder configuration information” (motor
identification number and encoder identification number) in
driver parameter No. 26 does not match the “motor/
encoder configuration information” (motor identification
number and encoder identification number) in encoder
parameter No. 11.
Check the parameter values, encoder cable connection,
etc.
Cold-st
art
lev
el
errors
D68 No remote-mode control support
board error
Hardware supporting remote-mode control is not installed,
although remote-mode control (AUTO/MANU) is specified
in I/O parameter No. 79.