Position value faulty [0x00910010, Error during initialisation [0x00910011, Block function in wrong mec task [0x00910012 – Lenze 9400 User Manual
Page 682: 0x00910012, 0x00920001, 0x00910011, 0x00910010, 0x00920000, 13 diagnostics & fault analysis

13
Diagnostics & fault analysis
13.7
Error messages of the operating system
682
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Position value faulty [0x00910010]
Error during initialisation [0x00910011]
Block function in wrong MEC task [0x00910012]
Safety module: Incompatible with setting in C00214 [0x00920000]
Communication with safety module interrupted [0x00920001]
Module ID (decimal)
Error ID (decimal)
145: Lenze runtime system
16
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
Internal error
If the error occurs frequently, please contact Lenze.
Module ID (decimal)
Error ID (decimal)
145: Lenze runtime system
17
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
Internal error
If the error occurs frequently, please contact Lenze.
Module ID (decimal)
Error ID (decimal)
145: Lenze runtime system
18
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
Internal error
If the error occurs frequently, please contact Lenze.
Module ID (decimal)
Error ID (decimal)
146: Interface to the safety module
0
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
The controller has detected a safety module which does
not match the setting under
.
Change setting under
or use a suitable safety
module.
• Afterwards mains switching is required.
Module ID (decimal)
Error ID (decimal)
146: Interface to the safety module
1
Response (Lenze setting printed in bold)
None System fault Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
It is not possible to establish communication between
the controller and safety module.
• Switch off the controller, plug in safety module
correctly and switch on the controller again.
• If the problem occurs again, replace the safety
module.