Lenze 9400 - Manual (Page 48)

4 Drive interface
4.2 Device commands
48
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.5 Save selected application
After mains switching the controller always loads the preset start application from the memory
module, even if a different application has been active before.
With the device command
C00002 = "7: Save selected application" the active application can be
defined as start application.
[4-15] "Save selected application" function
• When this device command is executed, the parameter set is also saved automatically.
• The number of the currently active application is displayed in
C00007 .
Possible status displays for this device command
Related device commands
 Activate application ( 47)
 Start application ( 53)
 Stop application ( 54)
* In this example, the active application 2 is defined as start application
PS
9400
RAM
Firmware Application 2*
PS
Application 3
Memory module MM
Application 1
Application 2*
PS
Status ( C00003 ) Meaning
492802 Device command in process
458752 Device command executed successfully
458753 General fault