Lenze 9400 - Manual (Page 556)

11 Basic drive functions
11.13 Cam data management
556
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to change an existing password:
1. Click upper Password button (for existing password).
2. Enter the existing user password in the Change password dialog box.
3. Click OK to accept the entry and close the dialog box.
4. Click the lower Password button (for new password).
5. Enter the new user password in the Change password dialog box.
6. Click OK to accept the entry and close the dialog box.

Tip!
An existing access protection via user password can be cancelled again by carrying out the
steps described before for changing the password and simply leaving blank the input field
for the new password.

How to link the cam data to the serial number of the memory module:
Go to the Serial number input field and enter the serial number of the memory module.
• When an online connection to the controller has been established, you can read out the
serial number of the memory module in the controller by clicking the Read from device
button.

Tip!
The linkage of the cam data to the serial number of the memory module can be cancelled
again by carrying out the steps described before and simply leaving blank the Serial
number input field.