Lenze 9400 - Manual (Page 784)

14 Parameter reference
14.2 Parameter list | C00392
784
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00392
C00393
C00394
C00395
Parameter | Name:
C00392 | CAN emergency delay time
Data type: UNSIGNED_16
Index: 24183
d
= 5E77
h
Time which at least has to elapse between two subsequent emergency telegrams.
• Setting "0" deactivates the inhibit time check.
• The inhibit time is entered in 1/10 ms. The code automatically rounds the entries down to the preceding full
millisecond.
• Mapping of the CANopen object I-1015 (see DS301 V4.02).
 "CAN on board" system bus
Setting range (min. value | unit | max. value) Lenze setting
0 65535 0
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00393 | CAN result - bus scan
Data type: UNSIGNED_8
Index: 24182
d
= 5E76
h
Result of CAN bus scanning (see controller commands under C00002 ).
• Subcode number 1 ... 128 corresponds to CAN node address 1 ... 128.
 "CAN on board" system bus
Display range (min. value | unit | max. value)
0 1
Subcodes Info
C00393/1 Result of CAN bus scanning for CAN node address 1 ...
128
• "1" means that a device with the corresponding node
address has been found.
C00393/...
C00393/128
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00394 | CAN predefined error field (DS301V402)
Data type: UNSIGNED_32
Index: 24181
d
= 5E75
h
 "CAN on board" system bus
Display range (min. value | unit | max. value)
0 4294967295
Subcodes
C00394/1
C00394/...
C00394/10
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00395 | Service code
Data type: UNSIGNED_32
Index: 24180
d
= 5E74
h
This code is for device-internal use only and must not be written to by the user!