Lenze 9400 - Manual (Page 537)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
537
11 Basic drive functions
11.12 Brake control
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.12.3 Mode 0: Brake control is switched off
If the mode 0 is selected in C02580 , the brake control is switched off.
• If a motor brake control module is available, it will not be triggered.
• The brake monitoring function is not active.
• A potential fault reported by the brake control is reset automatically.
• The output signals of the system block LS_Brake are reset:
• BRK_dnState = 0
• BRK_bReleaseBrakeOut = FALSE
• BRK_bBrakeReleased = FALSE
• BRK_bError = FALSE

Note!
In the Lenze setting, the mode 0 is preset to get into a safe state after the mains is
switched on.