Lenze 9400 - Manual (Page 55)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
55
4 Drive interface
4.2 Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.11 Reset program
The C00002 = "33: Reset program" device command is used to reset the application program in the
controller.
• All variables are reset to their initialisation value.
• The situation corresponds to the start of a new program loaded into the control (cold start).
Possible status displays for this device command
Related device commands
 Delete program ( 56)
 Restart program ( 57)
Status ( C00003 ) Meaning
2196738 Device command in process
2162688 Device command executed successfully
2162689 General fault