Lenze 9400 - Manual (Page 116)

5 Motor interface
116
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to get to the dialog for setting the motor interface parameters:
1. Go to the Project view of the »Engineer« and select the 9400 HighLine controller.
2. Select the Application parameters tab from the Workspace.
3. Click the following button of the Overview dialog level:
Parameterisation dialog in the »Engineer«
• The white buttons indicate the configuration of the motor interface inputs.  Internal
interfaces | "LS_MotorInterface" system block ( 231)
• The configuration is predefined by the technology application selected (in this example
"Actuating drive – speed"). If required, this configuration can be changed by clicking the
corresponding buttons.
• If you click a button marked with the symbol, you go one level deeper in the corresponding
parameterisation dialog.