Lenze 9400 - Manual (Page 699)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
699
13 Diagnostics & fault analysis
13.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Motor brake: Status monitoring error [0x00b80005]
Positive software limit switch overtravelled [0x00b80007]
Negative software limit switch overtravelled [0x00b80008]
Positive direction of rotation limited [0x00b80009]
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 5
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Faulty external feedback of the brake status to the brake
control.
• Check brake configuration with regard to the control
selection in C02580 .
• Check setting for status input monitoring in C02583 .
When monitoring is active, the input bBrakeApplied
must be triggered correctly (bBrakeApplied =
bBrakeReleased).
• Check voltage supply of the brake module.
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 7
Response (Lenze setting printed in bold) Setting: C02716/2 ( Adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The positive software limit position parameterised in
C02702/2 has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 8
Response (Lenze setting printed in bold) Setting: C02716/2 ( Adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The negative software limit position parameterised in
C02702/1 has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 9
Response (Lenze setting printed in bold) Setting: C02716/1 ( Adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Due to the setting of C02707 it was tried to traverse in
the impermissible positive direction of rotation.
• Only traverse in permissible (negative) direction of
rotation.
• Change setting of the permissible direction of
rotation ( C02707 ).