Lenze 9400 - Manual (Page 901)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
901
14 Parameter reference
14.2 Parameter list | C02853
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02853
C02854
C02855
C02856
Parameter | Name:
C02853 | Lss sat. characteristic
Data type: UNSIGNED_16
Index: 21722
d
= 54DA
h
Setting range (min. value | unit | max. value)
0 % 400
Subcodes Lenze setting Info
C02853/1 100 % Saturation characteristic to correct the leakage
inductance and the current controller parameters.
• The saturation characteristic is defined by 17
interpolation points which are distributed linearly on
the x axis.
• Interpolation point 17 represents 100 % of the
maximum motor current in the process ( C02855 ).
• The values to be entered in the subcodes represent
the y values of the interpolation points 1 ... 17.
 Correction of the leakage inductance via saturation
characteristic
C02853/2 100 %
C02853/3 100 %
C02853/4 100 %
C02853/5 100 %
C02853/6 100 %
C02853/7 100 %
C02853/8 100 %
C02853/9 100 %
C02853/10 100 %
C02853/11 100 %
C02853/12 100 %
C02853/13 100 %
C02853/14 100 %
C02853/15 100 %
C02853/16 100 %
C02853/17 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C02854 | Service code
Data type: UNSIGNED_32
Index: 21721
d
= 54D9
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C02855 | Imax f. Lss sat. characteristic
Data type: UNSIGNED_32
Index: 21720
d
= 54D8
h
Maximum motor current in the process
• Defines the interpolation point 17 of the saturation characteristic set in C02853 .
 Correction of the leakage inductance via saturation characteristic
Setting range (min. value | unit | max. value) Lenze setting
0.0 A 6000.0 5.4 A
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C02856 | Service code
Data type: VISIBLE_STRING
Index: 21719
d
= 54D7
h
This code is for device-internal use only and must not be written to by the user!