11 basic drive functions – Lenze 9400 User Manual
Page 503
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
503
11
Basic drive functions
11.11
Limiter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Inputs
Identifier
DIS code | data type
Information/possible settings
LIM_dwControl
| DWORD
Interface to the safety module (bit coded)
• For a simple connection of the safety module to the application, the transmission
of the currently valid safety requirement(s) is effected via this bit coded control
signal.
• It is also possible to make several requirements at the same time via the control
signal, e.g. manual jog with limited increment and limited speed 2.
• Bits not listed are reserved for future extensions!
Bit 0 Switched-off torque: request controller inhibit.
• This bit is no longer supported by the control signal of the
LS_SafetyModuleInterface system block.
Bit 1 Stop 1: request quick stop with subsequent controller inhibit.
Bit 2 Stop 2: request quick stop.
• If the automatic brake operation is activated, the brake remains
open at standstill.
Bit 3 Request limited speed 1.
• Change of the traversing profile according to the parameters set
for the limited speed 1 (
• Only effective for the basic functions "
Bit 4 Request limited speed 2.
• Change of the traversing profile according to the parameters set
for the limited speed 2 (
• Only effective for the basic functions "
Bit 5 Request limited speed 3.
• Change of the traversing profile according to the parameters set
for the limited speed 3 (
• Only effective for the basic functions "
Bit 6 Request limited speed 4.
• Change of the traversing profile according to the parameters set
for the limited speed 4 (
• Only effective for the basic functions "
Bit 7 Only permit positive direction of rotation.
• Only effective for the basic functions "
Bit 8 Only permit negative direction of rotation.
• Only effective for the basic functions "
Bit 10 Limited increment
• Activate maximum distance set in
for the basic function "
".
Bit 12 Defined limit positions
• Activate software limit positions set in
and