Lenze 9400 - Manual (Page 809)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
809
14 Parameter reference
14.2 Parameter list | C00644
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00644
C00645
C00646
C00647
Parameter | Name:
C00644 | PolePosId 360° fault tol.
Data type: INTEGER_32
Index: 23931
d
= 5D7B
h
From software version V4.0
Fault tolerance for the plausibility check of the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
-6.0 ° 30.0 0.0 °
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C00645 | PLI 360° absolute current amplitude
Data type: UNSIGNED_32
Index: 23930
d
= 5D7A
h
From software version V7.0
 Adjustment of the pole position identification
Display range (min. value | unit | max. value)
0.00 A 1000.00
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00646 | PLI min.mov. curr. amplitude
Data type: UNSIGNED_32
Index: 23929
d
= 5D79
h
From software version V4.0
Percentage adjustment of the current amplitude for the pole position identification
Stop!
If there is no temperature monitoring in the motor and/or the I2xt motor monitoring is not parameterised correctly,
the motor may be permanently damaged when the current amplitude is set too high (e.g. to the maximum value)!
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
1 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00647 | PolePosId min.mov. cur.rise rate
Data type: UNSIGNED_32
Index: 23928
d
= 5D78
h
From software version V4.0
Percentage adjustment of the rate of current rise for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
5 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1