2 parameter setting, Parameter setting, 11 basic drive functions – Lenze 9400 User Manual
Page 507
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
507
11
Basic drive functions
11.11
Limiter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.11.2
Parameter setting
• Parameterisation dialog in »Engineer«: Tab Application parameters Dialog level Overview
All basic functions Limiter
• Short overview of the parameters for the limiter:
Parameter
Info
Software limits pos. effective
Positive software limit position
Negative software limit position
Limitations effective
Max. speed
Max. speed [rpm]
Max. acceleration
Min. S-ramp time
Permissible direction of rotation
Limited speed 1 .... 4
Limited speed 1 .... 4 (display in [rpm])
Dec. limited speed 1 .... 4
S-ramp time limited speed 1 .... 4
Dec. time limited speed 1 .... 4
Max. manual jog distance
Max. dist. manual control (display in [increments])
Limitation active (status display)
Resp. to rotation limitation
Resp. to SW lim. pos. exceeded
Resp. to max. value exceeded
Observation software limit positions
Greyed out = display parameter
Note!
The safety module has its own parameters.
Relevant to the basic function "Limiter" are the parameters of the safety modules for
setting "Limited direction of rotation", "Speed with time limit" and "Limited increment
(position)".
However, several other parameters of the safety module have no significance for the
basic function "Limiter", e. g. the parameters for the configuration of the inputs of the
safety module.