Lenze 9400 - Manual (Page 705)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
705
13 Diagnostics & fault analysis
13.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Int. overflow C02701/1 (positive software limit position) [0x00b80020]
Int. overflow C02701/2 (negative software limit position) [0x00b80021]
Int. overflow C02703 (maximum speed) [0x00b80022]
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 32
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02701/1 .
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 33
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02701/2 .
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 34
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02703 .