Lenze 9400 - Manual (Page 76)

4 Drive interface
4.2 Device commands
76
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.29 CAN module: Reset node
The C00002 = "92: CAN module: reset node" device command is used to reinitialise the CANopen
interface of a CANopen communication module in module slot MXI1 or MXI2, which is required, for
instance, after the data transfer rate, node address, or identifiers have been changed.

Tip!
Detailed information on the CANopen communication module (E94AYCCA) can be found in
the "CAN" Communication Manual.
Possible status displays for this device command
Related device commands
 CAN module: Pred.Connect.Set ( 78)
 CAN module: Identify node ( 80)
Status ( C00003 ) Meaning
6063362 Device command in process
6029312 Device command executed successfully
6029313 General fault
6068736 CAN fault
...
6068991 CAN fault