Lenze 9400 - Manual (Page 550)

11 Basic drive functions
11.12 Brake control
550
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Sequence
If all requirements mentioned before have been met, the brake test can be started by setting the
input BRK_bBrakeTest to TRUE.
[11-47] Sequence of the brake test
Error behaviour
If during the brake test the stop position of the motor axis has changed by more than the
permissible angle of rotation set in C02595 , although the brake is engaged:
• The brake test is cancelled immediately and "Quick stop by trouble" is activated as error
response to avoid a further rotation/acceleration of the drive.
• The error message "Motor brake: Angular drift with closed brake too high" is entered into the
logbook.
• The status "position drift when brake is applied" is displayed for one cycle at the BRK_dnState
status output via bit 21 and the status "brake error" is displayed via bit 15.
• The BRK_bError output is set to TRUE for one task cycle.
 Normal behaviour
 Error behaviour
 C02594 : Test torque
 C02595 : Permissible angle of rotation
CINH = controller inhibit
• The specified test torque is created via a
ramp generator with an acceleration time
of 1 s and held max. 4 s.
• By this the motor shaft tries to rotate
while the brake is applied.
• By resetting the input BRK_bBrakeTest to
FALSE the brake test can be aborted.
t
?
0
1
M
t
j
t
t
BRK_bBrakeTest
CINH
C2605/1 C2605/2


t
BRK_bError
C2605/3