Lenze 9400 - Manual (Page 830)

14 Parameter reference
14.2 Parameter list | C00989
830
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00989
C00990
C00991
C00992
Parameter | Name:
C00989 | SLVC: Time const.- Para. adj.
Data type: UNSIGNED_32
Index: 23586
d
= 5C22
h
From software version V3.0
 Sensorless vector control
Setting range (min. value | unit | max. value)
0 ms 20000
Subcodes Lenze setting Info
C00989/1 20000 ms SLVC: Time const.- Para.Rs adj.
C00989/2 20000 ms SLVC: Time const.- Para.Lh adj.
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00990 | Flying restart: Activation
Data type: UNSIGNED_32
Index: 23585
d
= 5C21
h
From software version V3.0
Note!
Only deactivate the flying restart for the V/f control or sensorless vector control if it is ensured that the drive is
always at standstill in the case of controller enable!
 Flying restart function
Selection list (Lenze setting printed in bold)
0 Off
1 On
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00991 | Flying restart: Current
Data type: INTEGER_32
Index: 23584
d
= 5C20
h
From software version V3.0
 Flying restart function
Setting range (min. value | unit | max. value) Lenze setting
0 % 100 15 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00992 | Flying restart: Start frequency
Data type: INTEGER_32
Index: 23583
d
= 5C1F
h
From software version V3.0
 Flying restart function
Setting range (min. value | unit | max. value) Lenze setting
-600.0 Hz 600.0 20.0 Hz
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10