Lenze 9400 - Manual (Page 799)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
799
14 Parameter reference
14.2 Parameter list | C00588
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00588
C00589
C00591
Parameter | Name:
C00588 | Resp. to failure t. sensor drive
Data type: UNSIGNED_32
Index: 23987
d
= 5DB3
h
Response to error/failure of temperature sensor for heatsink temperature/temperature inside the controller
Selection list
(Lenze setting printed in bold)
1 Fault
5 Warning
0 No response
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00589 | Resp. to CPU temp. > C00126
Data type: UNSIGNED_32
Index: 23986
d
= 5DB2
h
Response if CPU temperature on the control card > variable limit temperature ( C00126 ).
Selection list (Lenze setting printed in bold)
1 Fault
5 Warning
0 No response
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00591 | Resp. to CAN-RPDOx error
Data type: UNSIGNED_8
Index: 23984
d
= 5DB0
h
Response if the corresponding CAN RPDO has not been received in the configured time or with the configured sync.
 "CAN on board" system bus
Selection list (Lenze setting printed in bold)
1 Fault
2 Trouble
3 Quick stop by trouble
4 Warning locked
5 Warning
6 Information
0 No response
Subcodes Lenze setting Info
C00591/1 0: No response Response to non-received RPDO1 ... RPDO4
C00591/...
C00591/4
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1