Lenze 9400 - Manual (Page 101)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
101
4 Drive interface
4.3 Device states
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.3.4 "Device is switched on" state
The drive is in this device status if the DC bus voltage is applied and the controller is still inhibited
by the user (controller inhibit).
• The bus systems are running and the terminals and encoders are evaluated.
• The monitoring functions are active.
• The controller can be parameterised and device commands can be executed to a limited extent.
• The functions of the user task can be used.
• Precondition: The application has started (status display in C02108 ).
• The basic drive functions cannot be used yet.
• If the controller is enabled, the motor builds up a torque.
4.3.5 "Operation" state
In this device state the motor follows its setpoint according to the basic drive function selected.

Danger!
If automatic restart is enabled ( C00142 = "1: Enabled"), the drive can restart
automatically from the "Trouble" and "Safe torque off" device states when the trouble or
request for "Safe torque off active" has been eliminated!
 Automatic restart after mains connection/trouble... ( 104)
LED DRIVE READY LED DRIVE ERROR Display in C00183
OFF 90: Drive is switched on
LED DRIVE READY LED DRIVE ERROR Display in C00183
OFF 0: Operation