Lenze 9400 - Manual (Page 808)

14 Parameter reference
14.2 Parameter list | C00640
808
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00640
C00641
C00642
C00643
Parameter | Name:
C00640 | Resp. to pole pos. id. monit.
Data type: UNSIGNED_32
Index: 23935
d
= 5D7F
h
From software version V4.0
Error response for abort of the pole position identification
 Adjustment of the pole position identification
Selection list (Lenze setting printed in bold)
1 Fault
4 Warning locked
0 No response
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00641 | PLI 360° current amplitude
Data type: UNSIGNED_32
Index: 23934
d
= 5D7E
h
From software version V4.0
Percentage adjustment of the current amplitude for the pole position identification
Stop!
If there is no temperature monitoring in the motor and/or the I2xt motor monitoring is not parameterised correctly,
the motor may be permanently damaged when the current amplitude is set too high (e.g. to the maximum value)!
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
1 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00642 | PolePosId 360° ramp time
Data type: UNSIGNED_32
Index: 23933
d
= 5D7D
h
From software version V4.0
Percentage adjustment of the ramp time for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
5 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00643 | PLI 360° traversing direction
Data type: UNSIGNED_32
Index: 23932
d
= 5D7C
h
From software version V4.0
Selection of the traversing direction for the pole position identification
 Adjustment of the pole position identification
Selection list (Lenze setting printed in bold)
0 Right rotating field
1 Left rotating field
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1